IC3D 120mm (4.7″) Wide 10M Long Kapton (Polyimide) Tape for 3D Printer platforms

November 16, 2014 - Comment

This is a 120mm (4.7″) wide by 22M long roll of Kapton tape (Polyimide). Enough to cover about 50 8×8″ glass sheets. We prefer this size since it’s easier to apply than full width sheets. Printing over heated Kapton taped glass allows for excellent adhesion of melted plastic and gives the bottom of your print

Buy Now! $17.99Amazon.com Price
(as of November 22, 2017 12:03 pm UTC - Details)

This is a 120mm (4.7″) wide by 22M long roll of Kapton tape (Polyimide). Enough to cover about 50 8×8″ glass sheets. We prefer this size since it’s easier to apply than full width sheets. Printing over heated Kapton taped glass allows for excellent adhesion of melted plastic and gives the bottom of your print a nice smooth finish. After many hours of printing, refresh your printing surface with this stuff. This tape can handle temperatures of up to about 280C. We’ve tested tape from several different manufacturers and chose the best. *** APPLICATION TIP: To minimize the seam from laying to sides down, just spray some lightly soaped water onto the glass and tape. Lay the first side down, slide to position, then squeegee the water out. Respray the second side if necessary, lay down the tape, slide to position to butt up against the first side, slowly squeegee out water. Let dry and trim off the sides. ***

Comments

Write a comment

*